The floors in living rooms are often recommended to lay on top of thermal insulation material so that the lion’s share of indoor heat could not leave through them. If the room is cold, if there is a constant problem with its heating, then listen to the following advice. Under a coating such as laminate, you can mount a warm film floor. After all, heating the rooms through central heating takes a lot of time. Resources (in the case of use for warming gas or electricity) are also spent a lot if the floors are cold. The problem will be solved most economically when you take care of the presence of a warm film floor under the laminate. It can be made auxiliary, or you can give it the main role. It must be remembered that cold air usually accumulates below, therefore it is advisable to produce heating from the floor – this will be more effective. Warm air strives upward, and therefore heating the floor contributes to its proper circulation. It is worth discussing some systems for heating the premises through a warm floor. They developed, undergoing changes.
In our life, high -tech warm film floors did not enter the laminate immediately. The first thing that was invented was heated on the principle of using pipes – “coils” with hot water located under the floor covering. They were connected to central heating. These pipes had a small section, their installation was very expensive, and repair was generally problematic. Later they began to introduce an electric “coil” under the floor. But this method gave a very strong electromagnetic radiation, harmful to human health. We can say that the best option is the modern technology of the film sex. , where the infrared base is used, and the coating is carbon. This does not harm the laminate at all and is absolutely safe. You can lay laminate boards of any class on top. Film floor thin, it does not reduce the total height of the ceiling above the floor in the room.