Very beautiful parquet floor. In addition, he is also durable. At the same time – quite “capricious”. Requires special care.
The main enemy of the parquet is moisture and mechanical damage.
Fighting these misfortunes is not difficult. It is more difficult to repair.
It is customary to call a parquet a parquet cut, and a board, and a saber. The last two are prefabricated shields, where any wood can be used from below in the form of a base. From above, the wood of more noble species.
The process of parking work is a bit of labor, but not even a specialist is quite capable of.
Since the parquet, in fact, is the final stage of the flooring, then the main attention should be paid to the preparation of the base and to the process of the flooring.
It is possible to lay parquet on a black floor or on a concrete base. Consider individually.
Real parquet is a whole art to collect a beautiful picture from numerous details. Remember how it was exciting to collect the design models in childhood. A whole creative process. And now you have the opportunity to re -survive the same impressions.
However, back to the instructions. Due to the large number of settled parts (maples), increased requirements are imposed on the base. According to technology, the distance between the lags cannot exceed 40-60 cm. Black floor is laid from boards with a thickness of 50 mm. The black board goes without a spong. Mandatory requirement-it is necessary to withstand bedding black floors for 1.5-2 weeks. After that, the floors must be driven. This can easily be done with an electric wheelchair.
Next, it is necessary to create the so -called compensating layer. It can be roofing ground, dense paper, covered on top of the blackboard.
When working with parquet, it must be remembered that the parquet in the drawing creeps around the light (window-door line). Whereas the draft floor – perpendicular to the scaptolo. It is preferable to lay the mrap on mastic.
We smear the floor with bitumen mastic, spread roofing material. We put Malkov (guides). If a certain drawing is not specified, then it is more practical to start either from the center of the room or from the door.
Pre -calibrated scenes are laid along the stretched cord (Malkka). Lubricate with mastic immediately before the clinker. It will not be superfluous to additionally nail each scythe for 3 nails. Two in the long side and one in the end. Parquet nail is considered a nail 40 mm long.
On a concrete basis – the same technology, only without the use of nails. We lay the first row. We lay the boards on top and press with the load. From opposite walls, we burst into wooden wedges. Let the mastic in the front row dry out. Only after that it is possible to continue to work, as well as pressing and bursting out each row.
The laid parquet must be polished by a parquet -building machine. Further, already if desired, we are either covered with mastic, or varnish.