The metal floor is mainly made for industrial and warehouse premises. Metal is a very hard and durable material, withstands heavy loads. Such a floor, no chemical compositions will not hurt, which are just very often used in industry. The service life of such a sex is more than 30 years. Currently, the metal floor was attracted to the designers. They advise laying such a floor in residential premises – in kitchens and in canteens. But metal coatings are mainly made for premises for production, and an ordinary citizen, in order to lay such a floor in his apartment, you need to run around the shops a lot, despite the fact that many domestic and foreign firms are engaged in their production. In the event that your kitchen is finished in the high-tech style, then the metal floor will very harmoniously fit into the interior. And if you mount the lamps on the floor, you will get a very stylish and unusual floor. The installation of a metal floor in arbors, on the tracks, on the roofs of houses, where you can go and relax, will be more rational. Floors from such material withstand any weather conditions. Currently, the thickness of metal sheets is one to two millimeters. The ability of the floor to withstand the loads, it directly depends on the thickness of the sheets used when laying the floors. Before you begin to lay the floors, take care of the surface on which the action will occur. First of all, you need to level the draft floor. Metal sheets are made in large sizes, so the seams will be smaller in those rooms where the area is larger. With the help of a wire brush, the lower part of the sheet is wiped, so that the sheets of metal after gluing are held tight on the floor. Excess glue must be removed from the metal floor using a conventional paper towel. There is also another way to lay a metal floor. This is when sheets of plywood are primarily glued to the black floor, and only then metal sheets. Further, with the help of silicone sealant, joints between the sheets are sealed. We must not forget about the main rule during the operation and installation of such a gender – in no case should you make the contact of your metal floor with electricity.
