Very often, when installing the bath, the gap between it and the adjacent walls form. So that the water does not fall on the floor, it is advisable to immediately close them up. Today we will tell you about the most affordable ways.
How to close the gap between the bathroom and the wall: let’s see.
Installation foam.
The easiest way to get rid of cracks can be using mounting foam.
– Buy a cylinder for domestic use, see how to use a gun for mounting foam, let it warm to room temperature, after which, properly, shake.
– The cylinder is ready for operation. Gently squeeze the mounting foam into the gap so that it does not fall on the floor.
– After the foam dries (it takes several hours) cut its protruding surpluses with a sharp knife.
– Thus, the cracks will be completely filled with soft material. For better waterproofing, apply a moisture -resistant white grout on top of the mounting foam.
Sealant.
Another option that you can use is suitable for masking narrow cracks. In this case, an acrylic or silicone sealant will come to your aid.
Both types of moisture resistance and differ only in color. The silicone composition is transparent. Acrylic – white.
It is important to properly prepare the basis for processing sealant. It should be fat -free, clean and dry. The sealant itself is sold in special plastic containers.
To squeeze it out, an additional device in the form of a metal syringe is needed. It costs inexpensively and is sold in any department with finishing materials.
How to close the gap between the bathroom and the wall with a rubber tape and a plastic corner.
Rubber tape.
There is a ready -made solution for the sealing of the cracks between the bathroom and the adjacent walls. This is a rubber tape. Its reverse side is equipped with an adhesive.
After removing the protective film, the rubber tape is glued to one part on board the bath, the other right on the wall.
So that the waterproofing grabs well with the base, it is advisable to additionally warm it with an ordinary hair hair dryer.
The adhesive will become a slurry and it is better to stick to the walls and the bathroom.
Plastic corner.
Do not hide a large gap with a rubber ribbon. Plastic corners or other borders are best suited for this.
They are wider than the tape and this is their advantage. It is most convenient to glue them using the glue “liquid nails”.
He is quite durable and is absolutely not afraid of moisture. Plastic corners regularly serve for 3-4 years. After that, we recommend replacing them with new.
Since glue gradually loses its strength, and the skirting boat in places does not fit firmly.
