Installation of a stretch ceiling is a certain sequence of actions that must be observed:
• Measurement of the height and ceiling level
Typically, one of two devices are used for this: level or hydraulic level. To determine the height and level of the ceiling, the point of the base is indicated, from which then you need to postpone 3-4 cm. From this new mark, the level of the ceiling plane begins.
• marking the location of built -in objects
This is due to the fact that for each light object that will have to be mounted, a holder is made – a stand. It must be taken into account that the placement of chandeliers, ventilation is based on the technical characteristics of the room.
• mount a special bar and holders for built -in objects
PVC Baget or aluminum bar installed on the wall is a frame. As “fasteners” use hot screws and plastic dowels. The fewer intervals in the joints of the bar and the higher the strength of the fastening, the higher the quality of the installation. According to the marking, the racks are fastened to the side ceiling. It is very important to carry out high -quality electrical wiring before installing the ceiling.
• Material stretch
Pulling should not be uneven. The stretched canvas should not be “impended” too much or weakly.
• Snapting with skirting boards
Before you buy a stretch ceiling, think about how you want to see the “top” of your room, what properties should buy. The fact is that you do not always need to end this work with a plinth. You can not use the edging at all if the stretch ceiling has a special type of attachment.
• Installation of lamps
Party lamps are installed and checked at the final stage of installation. It is worth noting that such “new” elements are associated with cuts in the stretch canvas, so first you should glue the places where the incision will not be damaged by thermal rings. It is also necessary to adjust the height of the platform before setting light devices.
• Cutting holes for a chandelier in a stretch ceiling
It is better to consult directly with the master so that no misunderstandings arise.
• bypassing the pipe
A film of stretch material is pulled around the pipe. The process is carried out with the cut of the canvas. “Chopped off” material must be treated with plastic. Typically, for this, a plate with a circle from a special plastic material is cut out and glued with good glue with an overlap on a stretch ceiling.
