You began to build a house or cottage, as a result of which you immediately got the question: where you can store the materials you need and tools?
From our article you can find out information on how to build a barn for their storage. By the way, the technology is very similar to the independent construction of a chicken coop.
How to build a barn with your own hands: step -by -step instructions
First
First of all, create brick chairs. They are needed to protect the lower strapping from dampness.
Second
Lay waterproofing on the chairs.
Third
Then lay the beam (sub -council). In this case, the corner compound should be “half -cod”.
At the mounting site, fasten the nails (100 mm).
Fourth
Depending on what the size of the construction is, set the number of racks you need, while the step should be 1.5 m.
Fasten the racks with nails (150 mm), as well as temporary struts (the angle should be 45 degrees).
Fifth
On the racks you will need to install the upper strapping. In this case, the corner compound should be carried out “in the half -core”.
At the junction of the strapping with the racks, it will be necessary to score nails (200 mm).
On the back, as well as on the front side of the barn, release 20 cm the ends of the upper binding.
Sixth
Put the crate on the top strainer. Spread the roles on top of the crate and beat the slate.
Seventh
Set the brown struts size 50 × 50 mm. Put the struts on the corner racks diagonally.
At the site of the planned door, install an additional rack, and fix the crossbar to it.
The eighth
Insert the door frame into the opening.
Ninth
Then the boards should be beaten on the barns. If trimming boards are used, they must be tightly nailed to each other.
If you use a non -coded board, it should be applied with alternation: at first with a review to yourself, then – already from yourself.
As a result, you will get a kind of castle in which one edge of the board will go after another.
The tenth step
Ready -made walls coordinate from the outside roofing ground. This is necessary in order to protect the barn from atmospheric precipitation.
The roofing material should be mounted from the bottom up so that the upper edge as if “run” over the lower.
Eleven
Put the floor boards on the bars of the lower binder.
Twelve
Select the door correctly and hang it, then install the lock.
The following materials are necessary for building a barn with your own hands
– a beam with dimensions of 100 × 100 mm;
– board 25 mm;
– The board is cut, having a section of 150 × 50 mm;
– slate;
– roofing material;
– brackets;
– nails (from 70 to 200 mm).
All. Now the shed for storing materials and tools is ready.
